Newland FM208 Guía de usuario descargar pdf (Pagina 16)

nlscan.com

Page 10

Getting Start

Programming Outline

Command Programming

The Programming Command (Pro CMD) pairs a unique Programming Code. Sending commands to the Imager

is identical with Code Programming. A full command is formed by [Start Symbol "nls" + Pro CMD = Parameters].

There are 4 ways to program a command:

"nls" + Pro CMD1.

E.g. [nls0100060], set RS232 transmit Baud Rate to 38400bps

"nls" + Pro CMD = Decimal Parameter2.

It is used to define

parameter, such as Min Message Length.

E.g. [nls0312040=10], select Sensor Mode Sensitivity to be 10

"nls" + Pro CMD = Hex Parameter3.

It is used to program Prefix, Suffix, Stop Bits, CodeID, Message Length, and Message Intersection.

E.g. [nls0310000=0x0d0a], program Suffix to be CR/LF

"nls" + Pro CMD = "Parameter"4.

Letters, digits and characters can be embraced by quotation mark as parameter.

E.g. [n

ls0300000="AUTO-ID"], program Prefix to be AUTO-ID

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 113 114

Sin comentarios

Newland FM208 Guía de usuario Pagina 16