Newland EM1300 Manual descargar pdf (Pagina 114)

nlscan.com

Page 105

Symbols

Tools

Code Programming ON

Code Programming OFF

Select Message Length

It is used to program the valid reading length of Code 93. The engine will

send an error beep, if the decoded data length does not match the valid

length.

Code 93 Message Length is deﬁned by “Min. Message Length” and

“Max. Message Length .”

Code 93

1D bar code Message Length should not exceed 255 bytes. If Max Message Length is less

than Min Message Length, it means the engine will only support barcodes of the two lengths.

If Max Message Length is equal to Min Message Length, the engine will only support

barcodes of the length.

To set Min Message Length of Code 93 to 8 bytes and Max Message Length to 12 bytes,

read these programming codes:

1.“Code Programming ON”

2.“Select Min Message Length”

3. Digit Code “8”, see Digit Code (Appendix Pxxx)

4.“Save Programming”, see Digit Code (Appendix Pxxx)

5.“Select Max Message Length”

6. Digit Code “1”

7. Digit Code “2”

8.“Save Programming”

9.“Code Programming OFF”

Min Message Length

【Pro CMD：99912606】

Max Message Length

【Pro CMD：99912607】

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 135 136

Sin comentarios

Newland EM1300 Manual Pagina 114