Newland EM1300 Manual descargar pdf (Pagina 100)

nlscan.com

Page 91

Symbols

Tools

Code Programming ON

Code Programming OFF

Select Message Length

It is used to program the valid reading length of Industrial 25. The engine

will send an error beep, if the decoded data length does not match the valid

length.

Industrial 25 Message Length is deﬁned by “Min. Message Length” and

“Max. Message Length ”.

Industrial 25

1D bar code Message Length should not exceed 255 bytes. If Max Message Length is less

than Min Message Length, it means the engine will only support barcodes of the two lengths.

If Max Message Length is equal to Min Message Length, the engine will only support bar-

codes of the length.

To set Min Message Length of Industrial 25 to 8 bytes and the Max Message Length to 12

bytes. Read these programming code:

1. “Code Programming ON”

2. “Select Min Message Length”

3. Digit Code “8”, see Digit Code (Appendix Pxxx)

4. “Save Programming”, see Digit Code (Appendix Pxxx)

5. “Select Max Message Length”

6. Digit Code “1”

7. Digit Code “2”

8. “Save Programming”

9. “Code Programming OFF”

Min Message Length

【Pro CMD：99912106】

Max Message Length

【Pro CMD：99912107】

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 135 136

Sin comentarios

Newland EM1300 Manual Pagina 100