Newland FM420 Manual descargar pdf (Pagina 114)

nlscan.com

Page 105

Symbols

Code Programming ON

Code Programming OFF

Tools

Aztec

Select Message Length

It is used to program the valid reading length of Aztec. The engine will not send

barcode message to the Host, if the decoded data length does not match the valid

length.

Aztec Message Length is deﬁned by “Min. Message Length” and “Max.

Message Length “.

2D bar code Message Length should not exceed 65535 bytes.

Max Message Length should not be less than Min Message Length.

To read a ﬁxed length Aztec, Please program Max & Min Message Length to the same

value.

To set Min Message Length of Aztec to 8 bytes and Max Message Length to 12 bytes,

read these programming codes.

1. “Code Programming ON”

2. “Select Min Message Length”

3. Digit Code “8”, see Digit Code

4. Save Programming”, see Digit Code

5. Select Max Message Length”

6. Digit Code “1”

7. Digit Code “2”

8. “Save Programming”

9. “Code Programming OFF”

Min Message Length (default: 1)

【Pro CMD：0503030】

Max Message Length (default: 3832)

【Pro CMD：0503040】

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 155 156

Sin comentarios

Newland FM420 Manual Pagina 114